Publicité
Les langues disponibles
Les langues disponibles
4.
Measure the length of the beams and cut the top
rail (sold separately) to same length. This should
match the cuts in Step 1. Press top rail end covers
onto the top rail and set in place on top of the
top beam (Fig. 10). Press down on the top rail to
ensure that it fits snugly onto the top beam and
ensure that top rail end covers are being held in
place by the mounting bracket.
5.
Using the holes in the bracket as a guide, pre-drill
two
/
" holes from under the bottom of the rail up
1
8
through the top rail as shown in Figure 11. Drive
two 1
/
5
bracket, panel, and top rail together, being careful
not to drill through the top of the top rail (circled
with dotted line).
" screws up through the hole locking the
8
Fig. 6
Fig. 8
A.
B.
Fig. 7
Fig. 9
Fig. 10
Fig. 11
5
Publicité
