PRO-POINT RED Serie Mode D'emploi page 9

V1.1 'Red Line' Variable Shade Auto-Darkening Welding Helmet
SELF-CHECK
1. Set the filter shading number anywhere
between 9 and 13.
2. Press the TEST button (#B4) to see if it
switches to the dark state.
3. Release the Test button to check that the
filter returns to the bright state.
GRINDING MODE
The welding helmet can also be used to protect the face during
grinding. Switching to Grind mode (#B3) will prevent the filter
cartridge from darkening when bright sparks are created.
MAINTENANCE
1. Maintain the tool with care. A tool in good condition is
efficient, easier to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace
damaged or worn components.
3. When servicing, use only identical replacement parts. Only
use accessories intended for use with this tool. Replace
damaged parts immediately.
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
CHANGE EXTERNAL AND INTERNAL LENS
The external and internal lenses will wear out and need
replacement after a period of use due to exposure to the heat,
fumes and particulate matter generated during welding.
1. Remove the filter cartridge by pressing the two lock switches
at the bottom of the retaining frame inwards. Pull the
retaining frame free from the welding helmet.
Visit www.princessauto.com for more information
8819914
Fig. 4
9