Installation Instructions - Summit SGWO30SS Mode D'emploi

INSTALLATION INSTRUCTIONS

CAUTION: Only qualified and authorized personnel should install or service this range. Improper
installation, adjustment, alteration, service, maintenance, or use of the range can result
in serious injury or property damage, and so the manufacturer will NOT be responsible.
This appliance must be installed in accordance with the manufacturer's installation instructions and
local codes. In the absence of local codes, refer to the National Fuel Gas Code, ANSI Z223.1 /
NFPA 54 in the U.S.A. and current CAN/CSA B149.1 Natural Gas and Propane Installation Code.
Clearance Dimensions
The appliance may be installed with zero inches of clearance adjacent to (against) combustible
construction at the rear and on the sides. For complete information regarding the installation of wall
cabinets around the oven and clearances to combustible walls, see the installation drawing fig. n°
08.
For Safety Considerations, do not install unit in any combustible cabinetry, which is not in
accordance with the installation drawings. The recess in which an oven unit is installed shall be
constructed so as to provide a complete closure around the recessed portion of the appliance, and
any openings around gas and electric service outlets shall be closed at the time of installation,
except when the construction of the appliance provides the necessary closure.
CAUTION: Some cabinets and building materials are not designed to withstand the heat produced
by the normal and safe operation of these appliances. Discoloration or damage, such as
delamination, may occur.
Locating the Oven
Do not install the oven beneath work counters. The bottom of the cut-out section of the appliance
installation must be located no lower than 16 inches (406 mm) from the floor, in accordance with the
manufacturer's instructions. Make sure the flow of combustion or ventilation air is not obstructed.
(See fig. 08 on next page.)
Ventilation
Ventilation must be in accordance with local installation codes. The appliance must be installed in a
well-ventilated environment to guarantee the correct combustion gases exchange, proper air
circulation, and working temperature within safety limits (see figure 08).
Model Number Plate
The Model Number Plate is located on the underneath case. A second Model Number Plate is
applied on the front page of the instruction booklet.
6