Summit SGWO30SS Mode D'emploi page 12

•
With LP gas, some yellow tips on the flames are acceptable. This is normal and adjustment is
not necessary.
NOTE: If the control knob is turned very quickly from HIGH to LOW, the flame may go out,
particularly if the burner is cold (oven burner). If this occurs, turn the knob to the OFF
position, wait several seconds and relight the burner. Refer to LOW SETTING VALVE
ADJUSTMENT chapter to adjust LOW setting, if needed.
Electronic Timer
When first powering on the oven, or in case of any electrical power failure, and power has been
restored, the electronic timer will start flashing. See Fig. 06.
Setting the Time
button. Set time of day with "+" and "-" buttons. The time will continue to flash for
Press the
seven seconds, and then the time will be set.
Adjusting the Time
Press the button for 4 seconds until the hours display flashes.
Change the hours only by using the "+" or "-" button. The minutes will not be affected.
Setting the Timer
•
Press the "+" button. Press "+" button again to increase duration time. The count units are in 10
second steps or minutes.
•
During countdown, the timer has priority on the display, and the bell symbol will be illuminated.
The units are in seconds, or minutes for longer time periods.
•
The maximum time is 10h. The format change will happen after 99 minutes and 59 seconds to 1
hour and 40 minutes.
•
To show time of day, press the
Resetting the Timer
Count down to zero by holding down the "-" button (automatic stop at zero).
Signal
The signal after "time out" will stay on for 7 minutes if it has not been reset with
following signal will be skipped if the time of day is pressed during the last 15 seconds of the timer.
button. After 6 seconds, the countdown will display again.
12
button. The