Indel B SAFE 10 E PLUS SMART Mode D'emploi page 32

All manuals and user guides at all-guides.com
SAFE 10 E PLUS SMART
AMEND
1. Press *4# + place "Owner key" on the receiver: lights will flash for 4sec;
2. While lights keep flashing input the corresponding ID for PIN code which you want to amend
followed by #: lights will flash for 4sec;
3. While lights keep flashing enter new PIN code followed by #: LCD will display "rEPE";
4. Enter again new PIN code followed by #: LCD will display "Succ";
5. PIN CODE will update to new one.
* 4
2 BEEP
• For setting and amend PIN code, if second time pin code entered is not same as first time, LCD
display "ERROR";
5. Delete MasterKEYs
• Same as MODE 1;
• The PIN code for each master key will be deleted at the same time when you delete the
corresponding master key.
• The PIN code will be deleted while all master keys are erased at one time.
6. Open the safe at Mode 2 with IB key  IB key + PIN code + #
Place the IB key
1 BEEP + LCD display "CODE" 1 BEEP
TO READ THE MASTER KEY ID PRESS *11# AND PLACE THE MASTER KEY, LCD DISPLAY "ID (1-5)"
FOR 4 SECONDS. This function must be used under MODE 1 as well.
• Synchronous function (this function must be used under MODE 1 as well)
• Synchronous setting to data card (yellow)
* 66
3 BEEP
• Copy setting to SAFES
* 55
3 BEEP
SAFE 10 E PLUS SMART_IM_20190905
Place the corresponding
#
owner key
master key/PIN+#
Pin code
Place the
#
owner key
Place the
#
owner key
Input the
New pin
code
ID (1-5) of the
4-6 digits
#
Place the data
card
Place the data
card
30
New pin
Pin
code
code
4-6 digits
SAFE open
P_Ed/Copy
complete
Setting copy to
other SAFE/P_Ed