Transportation And Storage; Cleaning And Maintenance; Circuit Diagram - CaterChef 688.240 Manuel D'utilisation

NOTES FOR INSTALLATION AND WORKING ENVIRONMENT
1. Machine should be installed by specialist!
2. Machine should be put in flat place, 10cm away from incombustible stuff on both side, 20cm away
from incombustible stuff(like brick wall) on the back.
3. Using voltage should match machine's standard voltage.
4. User need to install suitable power switch, fuse protector, leakage protector near the machine, no
stacking of debris near power switch.
5. Potential connection terminals are on the back down position, should be well connected according to
require standard.
6. Ground wire(yellow and green wire) are combined with power line together, ground wire should be
well connected with safety performance brass bolt.
7. Check electronic component of pasta cooker if they connect well before starting up.
8. Environment temperature should not above 50°C

TRANSPORTATION AND STORAGE

During the transportation, machine should be handle with care, prevent strenuous vibration, well packed
pasta cooker should not open storage over a long period of time. Machine should be put in warehouse
with good ventilation, non-corrosive gas condition. Do not place up side down, apply the protective
measure of rain.

CLEANING AND MAINTENANCE

To prevent accident, cut off the power switch during cleaning.
Use wet towel with non-corrosive cleanser to clean the exterior of the machine and power supply line after
daily work. Prevent to damage the performance, spray water for washing is forbidden.

CIRCUIT DIAGRAM

688240-042 G22NEF
5