Basic Parameters - CaterChef 688.240 Manuel D'utilisation

For giving full play to our product performance, please read instruction carefully before using the machine,
and keep it properly for reference in future.
It's an electric high-efficiency pasta cooker which developed by our company, with fast speed heating,
unique style, reasonable structure, easy operation.
Warning: Ensure the safety of using machine, it must be contact with ground, thank you!
Warning: The installation of this cooker need specialist to operate.

BASIC PARAMETERS

Model
Voltage
Power
NOTES
1. Heating in dry condition is prohibited, please add 1/2 cylinder water before using the machine, should
be not too much, in case get scalded.
2. The temperature controller is on the surface, it can be used alone, and also can be used at the same
time, temperature controller on the left control left pot temperature; temperature in the middle control the
middle pot temperature, temperature on the right control the right pot temperature.
3. Power on, the green indicator light on, switch the temperature controller clockwise, yellow indicator light
on, now the electric is supplied the machine, heating tube start to work, when heat reach the specified
temperature, the electric power will be cut down automatically, at the same time, yellow indicator light
off, heating tube stop working. When temperature drop slightly, temperature controller will get power
on again, yellow indicator light on, heating tube start to work again, temperature increase, to make sure
the constant temperature within a given range.
4. According to request to adjust the temperature, can make the food achieve the desire effect.
5. If there is any abnormal phenomena, stop the machine immediately, after current fault remove, then start
to reuse.
GENERAL FAULT HANDLING
Fault phenomena
1. Turn on the power switch, but
indicator light doesn't shine.
2. The yellow indicator light
doesn't off, can not control
the temperature.
3. Indicator light doesn't shine,
temperature thermostat is
working.
4. The yellow indicator light is on,
but thermostat is not working.
4
*688.240
230 V/50 Hz
3000 W
Reason
1. Power switch fuse burn-out.
2. Loose contact of power line.
1. Wrong connection of
indicator light line.
2. Temperature thermostat is
broken.
1. Bad connection of indicator
light line.
2. Indicator light is broken.
1. Wrong connection of
indicator light line.
2. The heating tube is broken.
*688.242
230 V/50 Hz
3000 W
Elimination methods
1. Change suitable fuse.
2. Fasten power line.
1. Correct the indicator light line.
2. Change the temperature
thermostat.
1. Fasten the light.
2. Change the indicator light.
1. Correct the indicator light line.
2. Change the heating tube.
688240-042 G22NEF 688240-042 G20NE