Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
An estimation of the level of exposure to vibration should also take into account the times
when the tool is switched off or when it is running but not actually doing the job. This may
significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibration such
as: maintain the tool and the accessories, keep the hands warm, organization of work
patterns.
LIST OF MAIN PART
Fig.1
1. Throttle trigger
3. Engine
5. Blower nozzle tube
7. Petrol cap
9. Primer
11. Outlet exhaust
13. Screw
15. Choke
17. Shoulder strap
19. Upper vacuum tube
ASSEMBLY
WARNING!
Stop the engine and put the on/off switch to "O" place before installing parts, making
adjustments, cleaning, or when not in use. Failure to do so could result in possible serious
personal injury.
Assembling the blower tube (Fig 2)
1.
Push the blower straight tube (4) and blower nozzle tubes (5) together and rotate until they
lock.(Fig 2.1 & 2.2)
2.
Use two normal screws(13) and lock the tubes together.(Fig 2.3)
3.
Push the assembled blower tube over the discharge port and rotate until locks in place and
the screw hole can be seen.(Fig 2.4 & 2.5)
4.
Fasten the tubes together using the two normal screws provided.(Fig 2.6)
Assembling the vacuum bag (Fig3)
WARNING! Never operate the vacuum without collection bag attached. Serious personal injury
could be the result if the blower vacuum is used without the bag fitted.
2. Grip handle
4. Blower straight tube
6. Recoil starter
8. Spark plug
10. Air filter
12. On/off button
14. Fuel tank
16. Bag tube
18. Collection bag
20. Lower vacuum tube.
22
Publicité
Table des Matières
