Table Des Matières; Safety - 3M CapMix Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
en
ENGLISH
CapMix
Capsule Mixing Device
Table of Contents
8. Operational Errors

1. Safety

CAUTION!
Please read these instructions carefully before you set up
and start the device. As with all technical equipment, this
unit will function properly and be safe to operate only if
both the general safety regulations and the specific safety
instructions laid out in these Operating Instructions are
followed.
1. The unit must be operated in accordance with the
following instructions. The manufacturer accepts no
liability for any damage arising from use of the unit
for any other purpose.
2. Prior to setting-up the device, ensure that the voltage
stated on the rating plate is identical to the available
main voltage. Use of the device at different voltages
may lead to the destruction of the unit.
3. The unit must be operated with the cover intact and
closed, otherwise, there is a risk of injury.
4. The cover must not be opened until the capsule holder
has come to a complete stop.
5. Only the capsule to be mixed but no other objects may
be present in the space below the cover when the
device is operated.
6. Placement or operation of the unit on non-level surfaces
is not permissible.
Page
7. When transferring the unit from a cold to a warmer
1
ambient temperature, there may be a hazard due to
2
condensation of water on the device. Hence, the unit
should only be operated after fully equilibration to
2
ambient temperature.
2
8. For operation of the unit, connect the main plug to an
adequate electrical socket with grounded lead. If an
2
extension cable is used, ensure that the grounded lead
2
is not interrupted.
2
9. Before replacing fuses, the device must be turned
3
off and the main plug must be disconnected from the
3
socket.
3
3
10. Only the appropriate fuses may be used for fuse
replacement. The use of recycled fuses or short-
3
circuiting of the fuse holder is prohibited.
3
11. In order to prevent electrical shock hazards do not
3
insert any objects into the unit with the exception of
3
replacement parts properly installed in accordance with
4
the present instructions.
12. If there is any reason to believe that the safety of the
4
device may be compromised, the unit must be put out
4
of operation and labeled appropriately to ensure the
4
device is not inadvertently used by a third party. The
4
safety may be compromised, for example, when the
unit fails to function properly or shows visible signs of
4
damage.
4
4
13. The device should be opened and repairs be carried out
only by qualified experts.
1

Publicité

Chapitres

Table des Matières
loading

Table des Matières