Mantion SLIDSOFT NM V121 Instructions De Montage page 15

Reversal of the functions of the transmitter buttons
This operation is necessary in case where the shutters open by pressing the (>< ) button of the transmitter.
Position the shutters near the 'close' position (approx. 10 to 15 cm). In this new position, start again the operation Learning mode
and saving.
DIAGNOSTIC HELP
symptoms
The learning cycle does not start.
The LED blink 4 times
The learning cycle does not start.
The LED is ON
The learning cycle does not start
The LED is OFF
The opening button make the
shutter closing
The closing button make the
shutter opening
The shutter does not start when there
is an opening or closing order
The shutter does not close completely
The shutter does not close completely
The shutter is hardly closing
The shutter is hardly opening
The drive is noisy (popping noise)
NM V121 A 02-2012
Possible causes
The battery pack is empty
The order is defective
The order is defective
The motor is not powered
The order is inverted
The order is inverted
The order is defective
The battery pack is empty
There is an obstacle or bad learning
The battery pack is empty
There is an obstacle or bad learning
The battery pack is empty
Bad learning
Bad learning
Belt relaxed
MANTION SAS
- 25000 Besançon - Tel +33 3 81 50 56 77 - Fax +33 3 81 85 38 79 - www.mantion.com
Solutions
Wait 6 to 8 hours before using the
shutter.
Verify that protective cover of the
battery is removedVerify that the
battery is not defective (the LED is ON
while pushing)
Verify that protective cover of the
battery is removedVerify that the
battery is not defective (the LED is ON
while pushing)
Verify the plug between the control
box and the power supply Verify the
power supply connection
Proceed to the reversal of the functions
of the transmitter buttons
(see programming instructions)
Proceed to the reversal of the functions
of the transmitter buttons
(see programming instructions)
Verify that the battery is not defective
(the LED is ON while pushing)
Verify the electrical wire plug : Wait 6
to 8 hours before using the shutter.
Remove the obstacle and/or do a
learning cycle again
Verify the electrical wire plug : Wait 6
to 8 hours before using the shutter.
Remove the obstacle and/or do a
learning cycle again
Verify the electrical wire plug : Wait 6
to 8 hours before using the shutter.
Do a learning cycle again
Do a learning cycle again
Tighten the belt
15/20