Needle Position - Texi Integra 5 Mode D'emploi

EN
1. Put the spool holder on the spool pin.
2. While using large cone spool use spool holders which are located in the
accosory box.
3.
Put the thread spool on the spool holder.

NEEDLE POSITION

As shown on the figure, installing the needles in different positions will effect in a
different stitch.
Note: If 2-thread chainstitch and cover stitch needles thread, the left needle is
slightly higher than the right needle.
92
Texi Integra 5 INSTRUKCJA 2019-ALL.indb 92 Texi Integra 5 INSTRUKCJA 2019-ALL.indb 92
This machine has
four different needle
positions. Up to two
needles can be stitched
at the same time. Fixed
screw A belongs to the
right side of the needle.
Fixed screw B belongs
to the left side of the
needle.
Fixed screw C
belongs to 2-thread
chain stitch of
the needle. Fixed
screw D belongs
to overlock of the
needle.
Texi Integra 5
A
Right overlock Left overlock
needle thread needle thread
B
A
Left and right overlock needles thread
C
2-thead chainstitch Cover-stitch needle
needle thread thread
C
2-thread chainstitch and cover-
stitch needles thread
B
D
D
18.09.2020 10:39 18.09.2020 10:39