Horizon Global 76583 Instructions D'installation page 3

Always wear SAFETY GLASSES
when installing hitch
Bumper bracket
1. Lower spare tire – Refer to vehicle owner's manual
2. Clamp bumper tabs – Use the C clamps to clamp the bumper tabs to the matching tabs directly above (1 each side) to prevent the bumper from
coming down when removing the factory M16 fasteners holding it to the vehicle frame.
3. Remove factory bolts – Using a 21mm socket, remove (4) M16 bolts holding the bumper brackets to the vehicle frame.
4. Install hitch – Raise the hitch into position, aligning the attachment holes in the hitch to the holes in the bumper bracket and frame rail. Re-install
the factory M16 bolts each side.
5. Torque fasteners – Tighten all M16 fasteners with torque wrench to 146Lb.-Ft. (195 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
6. Reinstall spare tire – Raise the spare tire back into position.
Note: Check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe
safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2022 Horizon Global Americas Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 76583, 84583, CQT76583
Fasteners typical
both sides
Figure 1
Bumper Tab
Factory M16 fasteners
Sheet 3 of 15 76583NP
Fastener Kit: 76583F
*No fasteners supplied in the
fastener kit
1-25-22 Rev. A