Technical Data - IB RUBINETTI 206 Notice De Montage

EN

TECHNICAL DATA

Minimum dynamic pressure: 0.5 bar
Maximum operational pressure: 5 bar
Recommended operational pressure: 1-5 bar
It's recommended to use a pressure reducer in case of
static pressure superior than 5 bar inside the waterpipe.
Maximum hot water temperature: 80°C
INSTALLATION, MAINTENANCE AND PRELIMINARY CHECKING PROCEDURE
In order to get your device work correctly and fine in time, must ensure compliance with the
mode of installation and maintenance described in this booklet. Relying on a qualified plumber.
Make sure that the system is free from all debris and impurities existing.
INSTALLATION
ATTENTION: The instructions are valid for the different models of spout and handle; the assem-
bly is always the same.
Fig. 1: Unscrew the screws from the carter and remove it. Unscrew the cover. Unscrew the
screws and remove the flat cover. ATTENTION: do not throw the 4 screws, you will need them.
Fig. 2 - 3: Position the cartridge lock in the built-in body, being careful to center the rear plug.
Fit the cartridge lock by tightening the four screws.
Fig. 2.2: For LoveMe series only, secure the cartridge lock with the screws supplied with it.
Fig. 4: Screw the spout support to the built-in body.
Fig. 5: Engage the spout and fix it with the screw.
After completing the installation of the cartridge lock and spout, turn on the stopcocks and
check that the mixer tap unit operates correctly. Keep the tap pressurised for a few minutes
checking eventual leaks.
Fig. 6: Insert the plate on the spout and on the cartridge lock.
Fig. 7: Screw the cover ring onto the cartridge lock. Insert the handle on the cartridge rod, fixing
it with the grub screw. Position the cover hole plug.
CLEANING
In order to obtain a correct cleanliness, exclusively wash them with soap and water, rewash and
dry them with a soft towel and deerskin. Avoid the usage of alcohol, solvents, solid or liquid
detergents which contain corrosive or acidic substances, abrasive sponges, swab with metallic
strings because they could irreversibly compromise the surfaces.
THE USAGE OF THIS KIND OF DETERGNETS DURING THE CLEANING OF THE MIXER EXCLUDE
IB RUBINETTERIE FROM ANY WARRANTY OBLIGATION.