Getting Started - LARQ Pitcher PureVis Mode D'emploi

Getting started

1 Remove the PureVis™ Wand from the LARQ Pitcher PureVis™. Give your LARQ
Pitcher PureVis™ a good wash before use.
2 Wake up your LARQ Pitcher PureVis™ by simply charging the PureVis™ Wand.
Connect the magnetic charger to the gold charging pins on top of the
PureVis™ Wand. We recommend a full charge to kick things off right.
3 Remove the filter from its packaging and soak the filter in water for 10
minutes before first use.
4 Install the filter into the reservoir and put the filter lid on. The lid should
snap into place. Press the Λ button for 5 seconds to let your pitcher know
you are installing a new filter (the indicator light will turn white for 5
seconds followed by a flash of blue light). Fill up the reservoir with tap
water. Pour out the first batch.*
The PureVis™ Mode will automatically activate after the LARQ Pitcher PureVis™
5
is completely filled. A blue breathing light indicates that the LARQ Pitcher
PureVis™ is on as water is filtered through. A 30-second PureVis™ cycle can
also be manually activated by pressing the Λ button.
Pour yourself a glass of water and enjoy pure water beyond filtration!
6
*Note: you may notice some black carbon dust in the water on your first use or after a prolonged
period of not using the LARQ Pitcher PureVis™. This is harmless carbon from our plant-based filter
media. If desired, simply run a batch through the filter and pour out.
06 English