Removing The Rechargeable Battery - LARQ Pitcher PureVis Mode D'emploi

Removing the rechargeable battery

DO NOT remove the battery until you intend to discard the product. Make sure that
the battery is empty of charge before removing it. DO NOT use a sharp object when
removing the battery. DO NOT puncture the battery. Please exercise basic safety
precautions when following the instructions below. Make sure the battery is
completely empty when you remove it. Observe safety precautions when following
the procedure below.
1 Take a pair of tweezers and pry
off the silicone button pad.
2 Remove the plastic button cover.
3 Remove the button board
connection.
4 Pull out the inner bracket,
removing the entire inner
component from the outer
casing.
5 Remove the LED board
connection.
16 English
6 Unscrew the two screws of the
control board.
7 Turn over the control board and
pull out the battery connector
(red, white & black wires).
8 Remove the holding pads and
remove the battery.
9 Remove the sensor connection
to complete battery removal.