Cal; Info; Report; Factory Settings - MACHEREY-NAGEL NANOCOLOR VARIO Mini Manuel

6.5.2 CAL

In the menu , the calibration of the heating block can be renewed with the help of the
NANOCOLOR
® USB T-Set (REF 919921). If the temperature inside the heating block is
higher than 70 °C, the calibration process starts as soon as the heating block is cooled
down to less than 70 °C.
After calling up the calibration menu the current date needs to be entered. The date can
be entered via the buttons
the correction of one digit of the date, the button
to this digit. After confirmation with
40 min).
During this process, a progress bar is displayed and you can see the
(Note: heating block is heating). This process can be stopped at any time by pushing the
button followed by confirming the alternately blinking
further confirmation, the calibration process is continued. The message "
after a successful calibration process. Confirmation with
data. In case of an unsuccessful calibration an exclamation mark
display. By pushing the
back to the T-Set menu.
Note: In case of deviations or a failed calibration, it is suggested to check the correct
positioning of the NANOCOLOR
data which are referring to the old calibration will be deleted automatically.

6.5.3 Info

By calling up the feature
shown. If the heating block was not calibrated or tested before, no data are shown here.

6.5.4 Report

By activating the option
sent to a connected USB-Stick. These data can then be used to create a certificate with
the software for MACHEREY-NAGEL heating blocks. A USB adaptor (REF 919937) is
required for the connection of a USB stick to the heating block.

6.6 Factory settings

In the factory settings menu
reset to factory settings. During this process all data generated by the customer regard-
ing tests, calibrations and the basic settings for sounds etc. are set back.
For setting back the device to factory settings push the
progress is displayed by the filling of the factory symbol. As confirmation you will hear a
sound. If the button is released within this time, the settings are not reset. Pushing
leads back to the superior menu.

6.7 Service menu

The service menu
service staff for maintenance.
30
(next higher number) and
the calibration process is started (duration up to
key, the new calibration is rejected in both cases and leads
USB-T-Set. After saving new calibration data, the test
®
the last calibration and test dates of the heating block are
the protocol of the performed test or calibration are
the settings of the NANOCOLOR
is locked by a service code. This menu is only to be used by
NANOCOLOR VARIO Mini V 1.0 / 01.16
®
(one digit to the right). For
can be used multiple times to get
and question mark. Without
saves the new calibration
is shown in the
VARIO Mini can be
®
button for five seconds. The
icon blinking
" is displayed