Castel XELLIP Serie Fiche Technique page 10

XELLIP MONITOR
CONNECTION
Connecting the power supply
Connection on 2-point terminal block
A 17-48Vdc power supply is required.
Note: The station can be powered by the POE network
Connecting the IP network
The connection is made by Ethernet 10/100 Mbits RJ45.
Connecting inputs E1 & E2
Two input TOR allows the connection of a dry contact (do not apply power) to be activated, the input must be pulled to
ground.
Connecting open collector outputs S1 &S2
Two open collector outputs allow controlling led or buzzer
Voltage should be between 5V and 12V.
When switch the output goes to 0V.
•
Schema 1
Schema 2
Datasheet n° 604-0032G
Masse
Relais Finder
22.21.9.4000
Moniteur
Monitor
ou Equivalent
S1/S2
350mA 12Vdc
MASSE
maximum
www.castel.fr
Alimentation
+
_
E1
E2
S1
S2
A1
Diode
Roue libre
External power
1N4004
Alimentation externe
12Vdc max
A2
FR
EN
Page 10 / 16