Next Level Racing FGT ELITE LITE Manuel D'instructions page 9

support@nextlevelracing.com
( )
LEFT
( )
RIGHT
19
Install 1 x 40x40 End Cap onto the rear end of each Pedal Arm. Align the through holes on the Left and Right Pedal Arms with
the mounting holes on the Pedal Arm Brackets. Bolt through and secure with 2 x M8 Bolts, Washers and Flange Nuts.
NOTE: The notches on
both Pedal Plates should
be facing inside.
20
Align the mounting holes on the Pedal Plates with the T-Nuts previously installed in Step 18. Bolt
through and secure with 8 x M8 Bolts and Washers.
F1/HYBRID PEDAL POSITION
Repeat
(Skip to Step 24 for GT pedal positioning.)
on other
side
21
Align the mounting hole and slot on the Pedal Adjustment Fin with the T-Nuts previously installed in
Step 01b. Bolt through and secure with 2 x M8 Bolts and Washers. Repeat on the other side.
PARTS:
Note: Do not tighten the
pedal bracket until you have • • 2 x M8 60mm Bolts
the desired position.
• • 2 x M8 Washers
• • 2 x M8 Flange Nuts
• • 2 x End Cap 40X40
PARTS:
• • 8 x M8 16mm Bolts
• • 8 x M8 Washers
• • 2 x Pedal Plates
PARTS:
• • 4 x M8 16mm Bolts
• • 4 x M8 Washers
• • 2 x Pedal Adjustment Fins
16
22
Align the adjustment slots on the Pedal Adjustment Fins with the T-Nuts previously installed in
Step 18. Bolt through and secure with 2 x M8 Bolts and Washers.
PEDALS ANGLE
ADJUSTMENT
Loosen the Bolts holding the Pedal Adjustment Fins to the Left and Right Pedal Arms. Adjust to the desired angle
23
and tighten the Bolts to secure in place. Use the angled slots to secure the Pedal Adjustment Fins in place to
maximize the strength of the assembly.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 2 x M8 16mm Bolts
• • 2 x M8 Washers
PARTS:
• • NIL
17