Next Level Racing FGT ELITE LITE Manuel D'instructions page 5

support@nextlevelracing.com
ALUMINIUM EXTRUSION TIPS
• Please do not use power tools for assembly as over tightening can damage your frame
• Please ensure T-Nuts are correctly placed within the extrusion
• Lay out and build the cockpit on a level surface
• Do not force parts together
• Avoid cross threading bolts
• If in doubt consult the installation video or contact us at support@nextlevelracing.com
• The F-GT Elite Lite is a two person build with the complete cockpit a two person move
• Beware of sharp edges on the extrusion pieces
ADJUSTMENT POINTS
The F-GT Elite Lite is fully adjustable from almost every attachment point making it great for
all sized users whether that be in GT or Formula position. Use the level provided along with
the adjustment markers on the frame to ensure perfect alignment.
FORMULA POSITION HYBRID POSITION
ANGLE HEIGHT DISTANCE
GT POSITION
Install cable clips at the location you
would like them during the build.
Leaving the installantion of cable clips to
the end can present installation issues.
Depress the alignment tab at the back
during installation.
8
LEFT
BACK
IMPORTANT: Place T-Nuts as shown in diagram below on the OUTSIDE of the Left Base.
(Red dots are T-Nuts placement)
Note: Slide 2 x Note: Slide 4 x
T-Nuts to the front for T-Nuts to the middle
for Wheel Post
Pedal Support
FRONT
01a
Slide 8 x T-Nuts into the outside channel of the Left Base.
Video Instruction: bit.ly/nlrbuild
NOTE: For easier installation hand screw M8 bolt
into T-Nut to assist sliding T-Nut into channel.
FRONT
RIGHT
Note: Slide 2 x
T-Nuts to the rear for
Seat Sliders
BACK
9