Next Level Racing FGT ELITE LITE Manuel D'instructions page 6

support@nextlevelracing.com
LEFT
BACK
IMPORTANT: Place T-Nuts as shown in diagram below on the OUTSIDE of the Right Base.
(Red dots are T-Nuts placement)
Note: Slide 2 x
T-Nuts to the rear for
Seat Sliders
BACK
01b
Slide 8 x T-Nuts into the outside channel of the Right Base.
NOTE: For easier installation hand screw M8 bolt
into T-Nut to assist sliding T-Nut into channel.
FRONT
RIGHT
Note: Slide 4 x
Note: Slide 2 x
T-Nuts to the middle T-Nuts to the front for
for Wheel Post
Pedal Support
FRONT
10
( )
FRONT
( RIGHT )
( BACK )
02 Align the threaded holes on the Front and Rear Base with the pre-drilled holes on the Right
Base. Bolt through and secure with 4 x M8 Bolts and Washers.
NOTE: Depress locater tab on back
side of clip to install into channel.
03
Suggested 1 x Cable Management Clip installation into the Rear or Front Base.
( )
FRONT
( )
RIGHT
( )
BACK
04 Align the threaded holes on the Front and Rear Base with the pre-drilled holes on the Left Base. Bolt
through and secure with 4 x M8 Bolts and Washers.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 4 x M8 40mm Bolts
• • 4 x M8 Washers
PARTS:
• • Cable Management Clip
PARTS:
• • 4 x M8 40mm Bolts
• • 4 x M8 Washers
11