Metrix HX0191 Notice De Fonctionnement page 13

Simplified connection boards :
• M12 connector
• Generic 8 wire connector
The connection boards are used for easy connection, by
insertion into your field buses. State measurements are
carried out using voltage probes associated with the
oscilloscope; to do this it is recommended to use the
probe's ground crocodile clamp (cold point) and a wire
clamp associated with the tip of the probe (hot point).
We recommend the electronic PROBIX sensor HX0130
1/10 to guarantee measurements using SCOPIX BUS.
The probe must be calibrated with the oscilloscope to
guarantee the measurements
As a supplement to these 2 connecting boards, we
propose the HX0190:
•
a connecting board with a SUBD9 connector
•
an RJ45 connecting board
•
an 100BASE-T connecting board
10
English
HX0191