Mitsubishi Electric JT-SB216JSH-W-E Mode D'emploi page 26

4 Tilt the panel (front) in the direction of the arrow, and remove it.
5 Remove the sensor fix holder (lower).
Assembly precaution
Take care not to pinch the lead wires.
6 Unhook the claw of the sensor fix holder (lower) (one location, indi-
cated by ), and remove the sensor circuit board (lower) (JT-30S3).

When reassembling
Reassemble the unit in the reverse order of disassembly.
After reassembly, always make a test run to be sure that the unit oper-
ates properly.
─ 26 ─
Sensor fix holder (lower)
Sensor circuit board (lower)
Sensor fix holder (lower)
(JT-30S3)