General Wiring Diagram - MaxLite Slim GuardMax SECS Serie Mode D'emploi

Operating Instructions
MaxLite Slim GuardMax
®

General Wiring Diagram

CAUTION: Turn off electrical power at fuse or circuit breaker
box before wiring fixture to the power supply.
Installation Instructions - Method 1
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the
fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
Note: There is an "UP" label on the fixture's backplate to indicate proper orientation.
Note: Add a bead of exterior grade silicone sealant around the perimeter of the wall pack on the wall to inhibit any moisture
1.
from attachment bolts.
Turn off the power.
4.
Peel off the yellow sticker
and apply it to the round
area of the bottom plate.
7.
If you do not wish to use the
photocell, unplug connector
located at the top of fixture
housing.
10.
Turn on the power after
making sure all screws are
tightend and the wire
connections are properly made.
© Copyright 2022. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
2.
Loosen the four screws shown in
diagram below.
5.
Fix the bottom plate to the
round plate.
8.
For CCT and Wattage
selectable models, set
preferences before closing
up the fixture.
30
20
15
SECS Series
HOT BLACK
NEUTRAL WHITE
GROUND GREEN
(+) DIM V+ PURPLE
(-) DIM V- PINK
3.
Remove the 1/2 end cap.
6.
Make your wiring connections.
Pink
Pink
9.
Replace bottom plate and
tighten the four screws.
Light
Fixture
Page: 3
REV: 01/20/22