Beper 90.131 Mode D'emploi page 13

Replace battery
When the scale does not light up and the message "LO" appears on the display
or the scale operates abnormally, it means that the batteries are low and must be
replaced.
Paying attention, open the battery compartment on the back of the scale, remove
the exhausted battery and replace it with one with the same technical characte­
ristics, and respecting the correct polarity, then close the battery compartment.
Cleaning
The scale can be cleaned with a soft cloth slightly moistened with warm water.
Never clean with abrasive products because they could damage the surface of
the scale. Do not immerse the scale in water. Do not allow any liquid to enter the
balance.
Technical features
Maximum flow rate: 5000 g / 11 lb
Graduation: 1 g / 0.1 oz
Power supply: 1X3V CR2032 button battery (included)
For any improvement reasons, Beper reserves the right to modify or im-
prove the product without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic
Equipment (WEEE), requires that old household electrical appliances
must not be disposed of in the normal unsorted municipal waste stream.
Old appliances must be collected separately in order to optimize the
recovery and recycling of the materials they contain, and reduce the
impact on human health and the environment. The crossed out "wheeled
bin" symbol on the product reminds you of your obligation, that when
you dispose of the appliance, it must be separately collected.
13
Kitchen scale - Use instructions
EN