Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL GE-DP 7330 LL ECO Mode D'emploi D'origine

Dirty water mode (Fig. 4/5):
•
Turn the equipment counter-clockwise up as
far as the stop (Fig. 4/5).
Shallow suction mode (Fig. 5):
•
Turn the equipment clockwise down as far as
the stop (Fig. 5).
•
In shallow suction mode, water can be su-
cked up down to a level of 1 mm.
•
Only clean water can be sucked up in shallow
suction mode.
Please note:
For the equipment to suck up water in shallow
suction mode there must be a minimum depth of
10 mm of water.

7. Replacing the power cable

Danger!
If the power cable for this equip-
ment is damaged, it must be
replaced by the manufacturer or
its after-sales service or similarly
trained personnel to avoid dan-
ger.
GB
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Cleaning the intake cage and pump
housing (Fig. 5/6/7/8):
1. Screw out the three screws (Fig. 6/Item B)
counter-clockwise.
2. Turn the equipment up as far as the stop (Fig.
5). Note the position of the lug (Fig. 5/Item A)
and remove the intake cage (Fig.7/Item 4).
3. Clean the intake cage (Fig. 7/Item 4) and the
pump impeller housing (Fig.7/Item C) with
clean water.
4. Assemble in reverse order.
5. When assembled, the lug must be in the cor-
rect position (Fig. 8/Item A).
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
- 21 -