koban KDP5 Mode D'emploi page 65

• To feed AC power cables through the side of junction box, please use the
cutting pliers to break the cable entry knockouts on the side of junction
box, then insert cables into junction box and feed through it. Strip off 6 -
8mm of cable sheathing for wiring (See FIG.16).
Cable entry
knockout
• Choose proper knockouts to fix the junction box JB-41 on the surface of
ceiling board with 2pcs wood screws attached with rubber washer
(See FIG.17).
Earth
terminal
• Insert 4pcs non-dropping screws to the corresponding screw holes on
detector's fixing plate, and those 4pcs screws will not drop off to provide
convenience to the subsequent installations (See FIG.18).
www.grupotemper.com
Highbay presence detector
6 - 8mm
FIG.16
FIG.17
Non-dropping
screw
Non-dropping
screw
FIG.18
KDP5
30 - 35mm
Rubber
washer
Instructions manual | 65