Audizio Prato 102.215 Manuel D'instructions page 9

Use "Timer On" to set a time for your radio to turn on automatically. Use "Timer Off" to set the time the radio turns off again.
1. In standby mode, press the [TIMER/CLOCK] button for about 3 seconds until the following message appears on the display:
2. Set the hour with the [
3. Set the minute using the [
4. The display now shows the following message:
5. Set the hour with the [
6. Set the minute using the [
7. Set the desired function (DAB / FM / DISC / USB) using the [
8. Adjust the desired volume using the [
9. Press the [TIMER/CLOCK] button for 3 seconds. Select "Timer On" or "Timer Off". In the standby mode, the icon "
appears on the display to indicate that the timer is on.
Set a time for your radio to turn off automatically.
1. To set the sleep time, press the [SLEEP] button on the remote control repeatedly to select the desired sleep timer. You can
select 90, 80, 70, 60, 50, 40, 30, 20 or 10 minutes switch off.
2. The time is now set
3. To cancel the sleep time, press the [SLEEP] button repeatedly to select "Sleep OFF".
Press the [EQ] button to switch between Flat, Classic, Rock, Pops and Jazz modes.
1. Set your radio to DAB+ mode.
2. Open the CD tray using the eject button on the remote control or on your radio.
3. Press and hold the [STOP] button until the following message appears on the display.
4. After the radio is reset, the DAB+ mode will be selected automatically.
Note: Please note that all programs will be deleted after the reset.
When the radio is connected to the power supply for the first time, the DAB+ mode will be switched on automatically. The
radio will automatically scan for suitable stations.
When station search is complete, you can use the [
displayed alphabetically. To select a station, press the [ENTER] key.
Full Scan
The "Full Scan" searches all DAB+ and Band III channels. After searching for a channel, the found channels are listed
alphabetically and the first channel is played back.
1. To activate the scan, press the [SCAN] button until the display shows
2. All found stations are automatically saved. Use the [
button on the remote control to select the station.
] or [ ] button and confirm with the [TIMER/CLOCK]-button.
] or [ ] button and confirm with the [TIMER/CLOCK]-button.
] or [ ] button and confirm with the [TIMER/CLOCK] button.
] or [ ] button and confirm with the [TIMER/CLOCK] button.
] or [ ] button. Confirm with the [TIMER/CLOCK] button.
] or [ ] button. Confirm with the [TIMER/CLOCK] key.
] or [ ]-button to tune in the individual stations. The stations are
] or [ ]-button to find the desired station and press the [ENTER]
9
"