Fax +32 2 359 95 50
OPERATION
The hair drying hood has two power settings.
0 – OFF
I – 180 W
II – 320 W
Before using the appliance, attach the hood to the main unit. The main unit is to be inserted in
the opening of the hood. Then pass the rubber ring situated in the edge of the hood over the
unit till it arrives in the fixing slot. After checking whether the rubber ring is correctly attached,
attach the flexible hood to the bottom of the main unit by attaching the press-stud. The
appliance is now ready for use.
When using the appliance, always let the flexible hood hang down.
CLEANING AND CARE
Unplug the appliance and let it cool down. Use a cloth to clean the hair drying hood. Make
sure does not become wet. If the air intake opening is dirty, please clean it.
When cleaning or repairing the appliance, we advise you to remove the flexible hood from the
main unit. To detach the flexible hood from the main unit, release the press-stud by pulling at
the tongue situated next to the press-stud inside the hood and take the rubber ring off the slot.
The textile hood is washable at 30°C.
AFTER USE
Unplug the appliance, let it cool down and store it. Never wrap the cord tightly around the
appliance. Never hang unit by the cord. Never pull at the cord, as this could damage the
appliance.
PROTECTION OF THE ENVIRONMENT – DIRECTIVE 2002/96/EC
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
implication of both suppliers and users. For this reason, as indicated by the symbol
rating label or on the packaging, your appliance should not be disposed of as unsorted
municipal waste. The user has the right to bring it free of charge to a municipal collection point
performing waste recovery by means of reuse, recycling or use for other applications in
accordance with the directive.
CUSTOMER SERVICE
efbe Elektrogeräte GmbH
Gustav-Töpfer-Strasse 6
07422 Bad Blankenburg / Thüringen
Germany
Tel : 00 49 36741 70268
Fax: 00 49 36741 70227
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
6
Assembly page 6/16
on the
LT 52 - 060118