Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
EMERGENCY INSTALLATION
NOTE: PLEASE FOLLOW ALL THE STEPS ON PAGE 2 FOR STANDARD INSTALLATION. ONCE COMPLETED PLEASE
FOLLOW THE STEPS BELOW TO ENSURE PROPER INSTALLATION OF THE EMERGENCY BATTERY PACK.
EMERGENCY
TEST SWITCH &
INDICATOR LIGHT
LED DRIVER
© 2018 Signify Holding. All rights reserved. This document contains information relating to the product portfolio
of Signify which information may be subject to change. No representation or warranty as to the accuracy or
completeness of the information included herein is given and any liability for any action in reliance thereon is
disclaimed. The information presented in this document is not intended as any commercial offer and does not
form part of any quotation or contract. All trademarks are owned by Signify Holding or their respective owners.
P/N 443560819190 Rev D
Page 3 of 4
PUREFORM BOLLARD (PBL)
1.
2.
3.
4.
2X 1/4-20x5/8"
HEX HEAD SCREWS
5.
EMERGENCY
BATTERY PACK
EMERGENCY
DRIVER
Signify North America Corporation
200 Franklin Square Drive
Somerset N.J. 08873, USA
Signify Canada Ltd./Signify Canada Ltée.
281 Hillmount Road,
Markham, ON, Canada L6C 2S3
UNSCREW (2) 1/4-20X5/8" HEX HEAD
SCREWS FROM TOP OF BOLLARD
SHAFT TO DETACH THE YOKE AND EX-
POSE THE DRIVER BRACKET.
COMPLETE THE CONNECTION AS
SHOWN BETWEEN THE TWO RED
WIRES. THIS MUST BE CONNECTED SO
THAT THE EMERGENCY BATTERY
PACK STAYS CHARGED.
ONCE CONNECTED CAREFULLY SLIDE
BOLLARD YOKE WITH ATTACHED DRIV-
ER BRACKET BACK INTO THE SHAFT.
MAKE SURE NOT TO PINCH ANY
WIRES.
ALIGN SCREW HOLES ON YOKE, GAS-
KET, AND SHAFT. TIGHTEN THE TWO
1/4-20x5/8" HEX HEAD SCREWS THAT
WERE REMOVED IN STEP 1 TO 10 FT-
LBS.
ONCE LUMINAIRE IS POWERED ON EN-
SURE THAT TEST INDICATOR LIGHT
TURNS ON. FOR A SHORT TIME TEST
(30 SEC) , LET THE UNIT CHARGE FOR
AT LEAST AN HOUR BEFORE PRESSING
EMERGENCY BUTTON TO ENSURE
BOLLARD CAN SWITCH OVER TO
EMERGENCY BATTERY POWER.
www.gardcolighting.com
Publicité
Table des Matières
