Installation Instructions; Standard Installation - SIGNIFY PureForm Serie Instructions D'installation

INSTALLATION INSTRUCTIONS

STANDARD INSTALLATION

NOTE: ANCHOR BASE IS SECURED TO GROUND WITH 3/8" BOLTS (ORDER W/ PBL). STRUCTURAL MEMBERS MUST
BE PRESENT IN GROUND TO ACCEPT BOLLARD BASE. SOME COMPONENTS SEEN IN VIEW MAY BE DIFFERENT
FROM THE PRODUCT RECEIVED. LUMINAIRE WILL STILL BE INSTALLED THE SAME AS SHOWN IN INSTRUCTION
SHEET.
BOLLARD SHAFT
ANCHOR BASE
LUMINAIRE
INPUT LEADS
SUPPLY LEADS
1-1/2" CONDUIT
CONCRETE
FOUNDATION
(BY OTHERS)
© 2018 Signify Holding. All rights reserved. This document contains information relating to the product portfolio
of Signify which information may be subject to change. No representation or warranty as to the accuracy or
completeness of the information included herein is given and any liability for any action in reliance thereon is
disclaimed. The information presented in this document is not intended as any commercial offer and does not
form part of any quotation or contract. All trademarks are owned by Signify Holding or their respective owners.
P/N 443560819190 Rev D
Page 2 of 4
4X 5/16-18 X 3/4" HEX
HEAD SCREWS
(SUPPLIED)
4X 3/8" LOCKWASHERS
& 3/8-16 LOCKNUTS
(ORDER W/ PBL)
4X 3/8"X8"X1-1/2"
ANCHOR BOLTS
(ORDER W/ PBL)
PUREFORM BOLLARD (PBL)
INSTALL FOUR (4) 3/8" X 8" X 1-1/2" ANCHOR BOLTS
1.
INTO CONCRETE FOUNDATION (ORDER W/ PBL)
UTILIZING TEMPLATE PROVIDED, (SEE BASE DETAIL
ON PAGE 4). ENSURE ANCHOR BOLTS PROJECT 1-
1/2" ABOVE CONCRETE SURFACE. CONDUIT PRO-
JECTION TO BE 1-1/2" MAXIMUM (BY OTHERS).
REMOVE LUMINAIRE FROM SHIPPING CARTON. UN-
2.
SCREW (4) 5/16-18 X 3/4" HEX HEAD SCREWS FROM
BASE OF BOLLARD SHAFT TO DETACH THE AN-
CHOR BASE.
PLACE BOLLARD ANCHOR BASE ONTO THE FOUR
3.
PREINSTALLED ANCHOR BOLTS. INSTALL FOUR (4)
3/8" LOCKWASHERS AND FOUR (4) 3/8-16 LOCK-
NUTS. SECURE ANCHOR BASE IN POSITION BY
TIGHTENING LOCKNUTS WITH 20 FT-LBS OF
TORQUE.
MAKE ELECTRICAL CONNECTIONS. FIXTURE LINE
4.
(BLACK) TO SUPPLY LINE, FIXTURE COMMON
(WHITE) TO SUPPLY COMMON AND GROUND
(GREEN) TO GROUND.
PLACE SPLICES AND EXCESS WIRE IN BOLLARD
5.
SHAFT. BE SURE TO NOT PINCH WIRES. CAREFUL-
LY SET BOLLARD UPRIGHT ON ANCHOR BASE.
ALIGN SCREW HOLES ON SHAFT WITH ANCHOR
6.
BASE AND SCREW IN THE FOUR 5/16-18 X 3/4" HEX
HEAD SCREWS THAT WERE REMOVED IN STEP 2.
TIGHTEN TO 10 FT-LBS OF TORQUE.
Signify North America Corporation
200 Franklin Square Drive
Somerset N.J. 08873, USA
Signify Canada Ltd./Signify Canada Ltée.
281 Hillmount Road,
Markham, ON, Canada L6C 2S3
www.gardcolighting.com