Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Clearing Pouch Jams
Pouches can jam due to the following:
■
the laminating pouch was not inserted straight into the laminator.
■
the transport rollers are soiled with residual adhesive.
■
an unsuitable laminating pouch or material has been used.
1
Switch the power switch to OFF.
2
Disconnect the power plug from the power socket.
3
Press the "ABS roller release" to the left and hold it at this position.
Î This releases the laminating pouch.
Caution!
Risk of burns through hot machine surface!
The laminator heats up during hot lamination. Wait a few minutes after switching off until
the laminator has cooled down before you touch it.
Caution!
Risk of burns through hot laminating pouch.
When the laminating pouch is ejected after lamination, it is extremely hot. Only remove
the ejected lamination pouch holding it at the cooled end.
4
Carefully pull the laminating pouch out of the infeed (rear) of the laminator.
5
Release the "ABS roller release" lever.
Î The pouch jam has been cleared.
6
Clean the laminator.
- 25 -
EN
Publicité
