Publicité
Les langues disponibles
Les langues disponibles
Positioning and Starting Up the Laminator
The following section should help when starting up the laminator.
1
Set the laminator down on a level, stable working surface close to an easily accessible power
socket.
2
Switch the power switch to OFF.
Only use the power cable supplied.
3
Connect the power cable to the connection socket in the laminator.
4
Connect the power plug to a power socket.
5
Switch the power switch to ON.
Î The transport rollers start to rotate.
Î The "COLD" status LED lights up GREEN
Î The laminator has been put into operation.
Before You Start
Please observe the following information to ensure continued reliable operation of the laminator.
Information on the Material
■
Do not laminate metallic, wet or uneven materials.
■
The material to be laminated, including the laminating pouch, must not be thicker than 0.5 mm.
■
Thin and soft materials should be laminated in laminating pouches with the largest foil thickness
(125 µ).
■
If possible, do not use too many small pieces of material in one laminating pouch.
Information on the Laminating Pouches
■
Only use foil pouches intended for lamination purposes.
Other types of foil, such as transparent film, are not suitable for laminating.
■
Only use hot laminating pouches for "Hot laminating" operating mode.
■
Only use cold laminating pouches for "Cold laminating" operating mode.
■
Choose the size of laminating pouch according to the material to be laminated.
■
If laminating pouches need to be cut, only cut the laminating pouches after laminating.
- 19 -
EN
Publicité
