TermaTech BIO 27 Notice D'installation, D'utilisation Et De Maintenance page 4

BIO 27 27 Χ 15 Χ 7,8
BIO 70 71 Χ 26 Χ 8,3
BIO 99 100 Χ 29 Χ 8,3
Safe Use Instructions
Before using the ethanol burner for the first time, make sure of the following:
▪ Remove all the packaging material, stickers and labels.
▪ Check the content of the packaging for any possible damage and make sure that all the parts are enclosed. Do not
use the burner if you realize any damage at the given parts.
▪ Make sure that you keep away all the packaging material from children. There is danger of accident or swallowing
parts.
Filling the burner with fuel
▪ To fill the burner with fuel, firstly you always draw the shutter to its closed position and then open the special filling
hole.
ATTENTION: Never fill the burner from its main opening because there might be small hearths, non-visible.
▪ Always fill the burner using the funnel to control the filling (e.g. funnel - See the Photo 4&5 - Page 7)
▪ Do not spill fuel out of the hole of the burner, there is serious danger of combustion. In case that fuel is spilt, wipe
carefully all the surfaces.
ATTENTION: Τhe fuel can destroy some surfaces (as wood, paint or skin).
▪ The burner is completely filled when the level of the fuel, during the filling, has reached the Max. mark. (The filling
is done in 2 steps. During the first filling, as soon as the fuel has reached the Max. mark, stop for 10-15'', letting it
absorb a part of the existent fuel. By the passage of the 10-15'', when the fuel level has been a little lessened, repeat
the same procedure till the fuel level reaches again the Max. mark.
Now the burner is completely filled.
▪ If the burner hasn't been ignited for ex. 12-14 hours, even if there is still ethanol in the burner, it has to be refilled
again
till max - this will give you a safe ignition.
▪ Especially for the first use the burner must be filled completely and slowly.
▪ Do not store the fuel close to the burner. Use safety distance, one meter at least.
▪ Use only Bioethanol fuel. Fuels of different type are forbidden and constitute threat if used with burner of this
type.
A good advice
▪ When the burner is filled till max in the 2 steps (as mentioned above), before you ignite the burner, you can check
if the
ceramic stone has been well moistened - this will give you a safe ignition.
ATTENTION: Do not smoke during filling the burner with fuel and for as long as you handle the fuel.
Ignition
The burner is ready for ignition after having been filled with fuel.
▪ Draw the shutter to the open position.
▪ Use a suitable long lighter for the ignition of the burner's surface.
▪ Do not put your hands on the surface of the fuel and do not stand over the burner while you turn it on. The ignition
of the burner must be done from the side and no parts of the body or flammable material should be over it.
▪ Do not blow towards the burner during the ignition there is danger that flames can cause burn injury.
▪ The burner does not produce the highest flame from the beginning. The highest flame result (temperature and flame
height) comes after 10-15 minutes of operation.
▪ Adjust the flame's height, with the provided tool, to adjust the size of the burner opening.
▪Avoid long periods of non-use of the burner while the fuel is volatile and will be vaporized.
▪ If the burner has not been ignited for longer periods it is important to be filled/refilled till Max - according to
1.25 L 4.50
3L 19.50
4L 30.00
4
3.0 15
4.0 44
4.5 70