Making Connections; Charging The Built-In Battery - Dynex DX-PDVD9 Guide De L'utilisateur

Setting up your DVD player

Making connections

Note: When making connections:
Connecting to the AC power adapter
To connect the AC power adapter:
1 Make sure that the supplied AC power adapter is correct for your local voltage.
2 Connect the supplied AC power adapter to the DC input jack on the left side of the
player, then to the AC power outlet.
Connecting to the cigarette lighter adapter in a car
To connect the cigarette lighter adapter in a car:
• Connect the supplied cigarette lighter adapter to the DC input jack on the left side of
the player, then to the automobile' s cigarette lighter socket.
Warning: To avoid traffic accidents, never wear headphones when driving a car or riding a

Charging the built-in battery

To charge the battery:
1 Turn off the player. The battery charges only when the power to the player is turned
off.
2 Connect the supplied AC power adapter to the DC input jack on the player, then plug
the adapter into an AC power outlet.
When the battery is charging, the charge indicator LED turns red. When the battery is
fully charged the indicator turns off.
3 Unplug the AC power adapter when the battery is fully charged.
Notes:
- Turn off the DVD player and other equipment.
- Fully insert the plug.
- Hold the plug while unplugging the cord. Do not pull the cord.
bicycle.
- While the charging is in progress, do not disconnect the AC power adapter until the
charge indicator LED turns off. The charging time of a battery is about 5 hours and
depends on environmental conditions.
- To maximize battery life, immediately recharge it when it is fully discharged.
- Ni-Mh batteries do not have a "memory effect" and can be recharged at any time,
regardless of whether the battery is fully or only partially discharged.
- The battery may get warm when you are charging it or operating the player. This is not a
defect.
9