Using Black Soap Nozzle - Echo PW-3100 Manuel D'instructions

USING THE BLACK SOAP NOZZLE
To apply detergent, follow these steps:
1. Review the use of spray tips.
2. Prepare detergent solution as required by the job. Use only certified detergent.
3. Place the small filter end of detergent siphoning tube into detergent container or
on-board soap tank (if applicable).
4. Connect the other end of the soap hose to the pressure washer pump.
NOTE: Make sure the filter is fully submerged in detergent during use.
Please note that only the BLACK NOZZLE will draw soap.
5. Ensure that the black spray tip is installed.
6. Make sure the garden hose is connected to the water inlet. Check that the high
pressure hose is connected to spray gun and pump. Turn water on.
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and without the water turned
ON will damage the pump.
• Damage to equipment resulting from failure to follow this instruction is not covered
by warranty.
7. Start the engine following instructions in Starting Your Washer.
8. Apply the detergent to the surface using long, even, overlapping strokes.
9. Allow the detergent to "soak in" for 5 minutes before washing and rinsing.
Reapply as needed to prevent surface from drying. DO NOT allow detergent to dry
on. This will damage paint clear coat, and other types of finish.
IMPORTANT: You must flush the detergent siphoning system after each use by placing
the filter into a bucket of clean water and running the pressure washer at low pressure
for 1-2 minutes.
Chemicals can cause bodily harm and/or property damage.
• NEVER use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergent/soaps. Follow all manufacturer
instructions and do not mix detergents with other types.
NOTICE
CAUTION
23