MALONE MPG201 Mode D'emploi page 4

MALONE
BEFORE YOU BEGIN: CONSULT FIT GUIDE FOR COMPATIBILITY
1). Remove the cross bars and components from the packaging. Using the key, remove the lock
cover. Insert the installation wrench into the hex head tightening bolt and turn counter clockwise to
widen the capture distance of the feet.
2). Lift the forward section of the tower to adjust it's position. Center towers over the raised side rails.
3). Place the cross bars onto the vehicle's raised
side rails. Adjust the distance between the
bars for the load to be carried.
Note: The bars must be separated
by a minimum of 24".
NOTE: Where items of equipment are being carried that may induce lifting forces (surfboards, sail boards, kayaks, canoes,
ladders etc.) All of these types of equipment should be secured independently to the front and rear of the vehicle using
Failure to correctly install and use safety tie-down lines voids all warranty and liability.
. Never assume a cross bar will fit. Always refer to Malone's Fit Guide for proper, correct and approved vehicle fit.
. Locks must be turned periodically and lubricated to ensure smooth operation. Use of a dry lubricant is recommended.
. Confirm that all bolts and locks are firmly secured prior to transport. Periodically check the load during transport.
. Do not continue to use the product if excessive corrosion, deformity or any mechanical defect is detected.
. Check local and state laws governing projection of objects beyond the perimeter of the vehicle.
. Malone locks are designed to deter vandalism and theft but should not be considered theft proof.
. Obey all posed speed limits and traffic cautions. Adapt your driving for the load being transported.
. Do not use Malone cross bars for purposes other than what they were designed for.
. Not for use on trailers or any other modes of transport other than vehicle rooftop transport.
. Failure to follow these guidelines will void the warranty.
. Remove the product before entering a carwash.
Warnings / Limitations: The load you are carrying plus the weight of the
rack must not exceed the maximum weight limitation of the vehicle's factory
raised side rails. Before installing, confirm your vehicle's factory specifications.
tie-down straps that are capable of withstanding the lifting forces (NOT INCLUDED).
Bow and stern safety tie-downs are required for all Malone rooftop transport(s).
MPG201 50" STEELTOP
MPG202 58" STEELTOP
MPG203 65" STEELTOP
R