Important - Viking VMOC206SS Guide D'installation

IMPORTANT–Please Read and Follow!
• Before beginning, please read these instructions completely and carefully.
• Be sure to DISCONNECT THE PLUG of the microwave oven from the electrical outlet before installing the built-in trim kit.
Remove the turntable from the oven cavity.
• Because the kit includes metal parts, caution should be used in handling and installation to avoid the possibility of injury.
• Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.
• Please observe all local and national codes and ordinances.
• The installer should leave these instructions with the consumer who should retain for local inspector's use and for
future reference.
• This built-in trim kit is designed for use ONLY WITH CONVECTION AND CONVENTIONAL MICROWAVE OVENS SPECIFYING
BUILT-IN TRIM KIT VMTK272, VMTK302, VMTK362, VMTK277, VMTK307 or VMTK367 on the rating label on the bottom
face plate of the oven cavity.
• YOUR OVEN CAN BE BUILT INTO A CABINET OR WALL BY ITSELF OR ABOVE ANY ELECTRIC WALL OVEN OR WARMING
DRAWER.
Parts Included in VMTK kits
Front Frame Assembly
Front Frame
QTY 1
Bottom Duct Assembly
Cushion QTY 6 *
E
QTY 1 27" & 30"Surface Mount
Template 2-sided
or 36"Surface Mount
Back Frame
Template single-sided
QTY 1
Maximum Cutout Opening Width 24-11/16" (627.06 mm)
Minimum Cutout Opening Width 24-3/8" (619.13 mm)
BUILT-IN TRIM KIT TEMPLATE
FOR CUSTOM SERIES MICROWAVE OVEN
Distance between holes A 25-9/16" (649.3 mm)
Distance between centerline to holes 12-13/16" (324.65 mm)
Distance between holes B 28-9/16" (725.5 mm)
Distance between centerline to holes 14-5/16" (362.75 mm)
Floor Line of Cutout Opening
QTY 1
*
Duct (A)-1
QTY 1
USE THIS SIDE OF TEMPLATE FOR MODELS
VMTK272 and VMTK302 ONLY.
Duct (A)-2
1. Align the mounting template center line with the center of the cutout
and the floor line with the floor of the cutout. Tape it into place.
2. For VMTK272, predrill 4 holes marked A with a 1/16" drill bit.
For VMTK302, predrill 4 holes marked B with a 1/16" drill bit.
3. Remove template from the cabinet.
Center Line
1-5/32"
(29.6 mm)
TINSKB182MRR0
Duct (B)
Duct (C)
1
QTY 1 *
Duct (A)-3
QTY 1 *
Screw A (1/2" length)
QTY 10 *
Screw B (1-3/4" length)
QTY 1 *
QTY 4
QTY 1 * Screw C (3/4" length)
QTY 2
*VMTK277, VMTK307 and VMTK367 ONLY.
QTY 1 *