Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Always wear SAFETY GLASSES
when installing hitch
Frame
weldnut
Conical washer
teeth side
against hitch
Fasteners
typical
both sides
Figure 1 (2010-12)
NOTE: On 2010-2012 models item 4 i s not required (see figure 1). On models 2013 a nd later tape item 4 i nto location on the top of the hitch a t the rear most hole (see figure 2) before
s ta rting s tep 1.
3.
Ra i se hitch into position a nd align the slots of the receiver with the weldnuts i n the frame rail.
4.
Ins tall the M12 X 1.25 X 40mm bol ts a nd conical toothed washers through the hitch and into the weldnuts.
5.
Ins ert the handle nuts through the large hole i n the vehicle frame rails as shown above i n figures 1 a nd 2.
6.
Ins tall the ½-13 X 1.75 bol ts and conical toothed washers.
7.
Tighten all M12 X 1.25 CL 10.9 fasteners to 76 Lb.-Ft. (103 N*M) and all 1/2-13 GR 5 fasteners to 50 Lb.-Ft. (68 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been
damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. D o not cut access or attachment holes with a torch. This product complies with safety specifications and
requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2021 Horizon Global Americas Inc. - Printed in Mexico
Gently pull down and
rearward at fascia
attachment for additional
clearance if needed at
cross tube.
q
Figure 2 (2013-Current)
o
Fastener Kit: 76902F2
⑨
Qty. (1)
⑩
Qty. (2)
j
k
l
m
n
p
o
p
q
n
m
F
Wa rni ng Card
Wa rni ng Label
Sheet 4 of 12
76902N
Fastener Kit: 76902F
Qty. (2)
Bol t
M12x1.75x100mm, CL10.9
Qty. (2)
Fl a t Washer 7/16''
Pa rt#: 0116007
Qty. (2)
Preva i ling Torque Nut
M12x1.75, CL10
Qty.(2)
Hex Bol t 1/2-13x1.75
Gr. 5
Qty. (4)
Coni cal Washer 1/2"
Pa rt no. 01292008
Qty. (2)
M12 x 1.25 x 40mm
CL 10.8
Qty. (2)
1/2" Ha ndle Nut
Pa rt no. 1332
Qty. (2)
Bl ock 0.25" x 1.50" x 2.0"
Pa rt no. 01097002
⑩
5-21-21
Rev. C
Publicité
Table des Matières
