Battery Operation; Checking The Welding Result; Checking The Safety Device - PAXXO PACTO SAFE 4.0 Manuel D'instructions

9. Battery operation (optional)
A battery is available as an optional extra when ordering.

If the red LED is constantly illuminated on the front panel, the machine may not be used.

The machine must be charged when the red LED is constantly illuminated on the front
panel.

The red LED may come on during welding.

Conserve battery power by switching off the machine if it is not to be used for a longer
period. Remember that the machine takes around 5 seconds to start after the switch has
been turned on.

Recharge the battery at least once a month to prevent it discharging completely.

The machine may not be used during charging.

The battery is fast charging if the orange LED on the charger is on.

Yellow led on charger, no battery is connected or when initializing starts.

If orange/green led is trickle, something is error with the charger/connection.

Green/yellow led lights when reaching topp-off charging

The battery is fully charged once the green LED comes on on the charger.

After about 6 hours of charging, the charger will go to trickle of charging.

Disconnect the charger once the green LED comes on.

Always disconnect the charger from wall before You disconnect from Pactosafe.

When charging, always connect to Pactosafe first before You connect to the wall.

To prolong battery life, the battery should be completely discharged prior to
charging and should then always be fully charged.

Pactosafe may only be used with Pactosafe charger Type 2216 made by Mascot.

10. Checking the welding result

It is important to check the result of the welding to ensure that the bags are hermetically sealed at least
once per year. Severe wear and tear on the welding bars can adversely affect the result.
The foil has not melted together

11. Checking the safety device

It is important to check the crush guard at least once per year.
Press on the foot pedal and hold an object of 10-20 mm thickness between the welding
bars.
The welding bars should return when they encounter resistance in excess of 8 mm in
thickness.
Check anually whether the stickers on the funnel are damaged, unreadable or missing.
Contact the manufacturer if they need to be replaced.
Paxxo AB / Bjurögatan 35, SE-211 24 Malmö, Sweden / Tel: +4640186025/ Fax: +4640183736 / www.paxxo.com
Correct welding joint.
Flat and even.
Holes in the foil, uneven
melting.
15