pico Technology PicoScope 2000 Serie Manuel D'utilisation page 10

PicoScope 2000 Series Oscilloscopes and MSOs
2.7 Conformance
General statement of conformity
The enclosed instrument has been calibrated in accordance with the manufacturer's
verification procedure using standards that are traceable to UK national standards. The test
location's quality management system complies with, and its calibration process is controlled
under, ISO 9001:2015. The calibration processes are designed to certify that the instrument
was within its published specification at the time of calibration. The measurements were
made in a monitored environment.
A full calibration certificate including test data and traceable to national standards is available
on request. Please refer to
FCC notice
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference which the
user will be required to correct at their own expense.
CE and UKCA notices
The PicoScope 2000 Series oscilloscopes meet the intent of the CE EMC directive 2014/30/
EU and UKCA SI2016/1091 EMC Regulations. This oscilloscope also meets the intent of the
CE Low Voltage Directive 2014/35/EU and UKCA SI 2016/1101 Electrical Equipment (Safety)
Regulations. For more information, please refer to your product's UKCA Declaration of Conformity
or EU Declaration of Conformity, available for download from www.picotech.com/downloads.
6 Copyright © 2006–2022 Pico Technology Ltd. All rights reserved.
picotech.com/products for pricing.
User's Guide
DO231-11