Cleaning And Maintenance; Technical Data - Adler europe AD 7007 Mode D'emploi

19. Do not aim the vacuum cleaner toward other people or animals.
20. The vacuum cleaner may be used only on dry surfaces.
21. Only use accessories designed for this appliance.
22. Use extra care when vacuuming stairs.
23. Do not block any vents.
24. Do not operate the vacuum cleaner without the filter.
25. Do not pull the vacuum cleaner by the hose.
26. Make sure that the power cord is not wedged by a door and does not get jammed.
When moving the vacuum cleaner please note the length of the power cord. Pulling the
vacuum cleaner suddenly when the cord is taut may damage it.
27.Vacuuming dust and residues of construction causes immediate loss of warranty. The
vacuum cleaner is designed for domestic use only.
DESCRIPTION OF THE DEVICE (Fig. 1)
1.1 Air intake 1.2 Button to open the dust container
1.5 Container (filter) removal button
1.9 Wand 1.10 Hose
USING THE DEVICE
Before use, check that the filter and the dust canister (bag) are in place.
1. Press the cord retractor (1.6) and pull the cord by the plug (Fig. 2.A).
2. Insert the hose end (1.10) to the air inlet (1.1)
3. Attach the wand (1.9) to the other end of the hose (1.10).
4. Slide the brush (1.11) on the end of the wand (1.9). Depending on the surface to be vacuumed, you can extend or retract the brush
bristles by pressing the button on the brush.
5. Plug the power cord in an electrical outlet.
6. Turn on the vacuum pressing the ON switch (1.4).
7. You can adjust the suction power by moving the slider on the wand.
8. When done vacuuming, turn off the vacuum pressing the OFF switch (1.4) and unplug the cord from wall outlet.

CLEANING AND MAINTENANCE

1. Disconnect the hose (Fig. 1.10) from air inlet (1.1).
2. Open the vacuum cover by pressing the dust container opening button (1.8)
3. Remove the bag by pushing up the bag handle (Fig. 2.B). Slide the bag from the handle (Fig. 2.C).
4. Slide the inlet filter out by pushing it upward (Fig. 2.D). Insert a clean filter in its place.
5. To change the exhaust filter: Slide the filter eject button (Fig. 2.E). Remove the cover and remove the exhaust filter (Fig. 2.F). Insert
a new filter in its place. Replace filters at least once after every five exchanges of paper bag.
6. Clean soiled cover with a damp cloth.

TECHNICAL DATA

Power source: 230 V ~ 50 Hz
Power: 700 W
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment. Do not dispose this appliance in the common waste bin.
LESEN SIE AUFMERKSAM WICHTIGE ANWEISUNGEN BEZÜGLICH DER SICHERHEIT
DER BENUTZUNG BEWAHREN SIE DIESE FÜR DIE ZUKUNFT AUF
Bei Verwendung des Gerätes zu gewerblichen Zwecken werden die Garantiebedingungen
1.6 Cord retractor button
1.11 Floor brush
ALLGEMEINE SICHERHEITSVORSCHRIFTEN
1.3 Handle 1.4 Power switch
1.7 Cord retractor
DEUTSCH
5
1.8 Wheel