U.S.Robotics USR5417 Wireless MAXg PCI Adapter Guide D'installation page 16

My computer does not recognise the Wireless
Possible Solution:
• The Wireless MAXg PCI Adapter may not be fully inserted into the PCI slot. You can also
try installing the Wireless MAXg PCI Adapter into a different PCI slot.
• Your PCI slot may not be configured correctly. To configure your PCI slot, contact your
computer manufacturer.
I am unable to communicate with an Access Point or Wireless Router.
Possible Solution:
Be sure that each Wireless MAXg PCI Adapter that you want to connect to the wireless
network is set to Infrastructure mode within the Configuration Utility. If your Wireless
MAXg PCI Adapters are not set to Infrastructure mode, they will not be able to
communicate with an Access Point or Wireless Router.
Possible Solution:
Determine the MAC address of the desired wireless router or access point. Using the U.S.
Robotic Configuration utility, check the MAC address and verify that you are connecting
to the correct wireless router or access point.
Possible Solution:
Ensure that the Configuration Utility is installed for your Wireless MAXg PCI Adapter and
that the Configuration Utility detects your Wireless MAXg PCI Adapter.
Possible Solution:
Ensure that the correct Authentication Mode and encryption key are being used. If you
changed the settings in the configuration of your Wireless Router or Access Point, you
must also change the settings of every Wireless MAXg PCI Adapter attached to this
network. The settings of your Wireless MAXg PCI Adapters must match the new settings
of the Wireless Router or Access Point. If you are still experiencing difficulties, reset all of
your Wireless Routers or Access Points and wireless network adapters to the default
settings and try again.
I accidentally clicked Cancel during the software installation procedure for the
Wireless MAXg PCI Adapter.
Possible Solution:
Remove and reinsert the Installation CD-ROM into your CD-ROM drive. Follow the
instructions in this guide for installing the software.
The U.S Robotics interface did not begin when I inserted the Installation CD-ROM.
Possible Solution:
Some programs may disable the autorun feature of Windows. Close any open
applications and reinsert the Installation CD-ROM. If the Installation CD-ROM interface
does not run automatically, click Windows Start and then click Run. In the "Run" dialog
box, type D:\setup.exe. If your CD-ROM drive uses a different letter, type that letter in
place of "D."
I inserted the Wireless MAXg PCI Adapter before the Installation CD-ROM.
Possible Solution:
If you inserted the Wireless MAXg PCI Adapter before the Installation CD-ROM, cancel the
installation procedure that is currently running. Insert the Installation CD-ROM, select
12
MAX
g PCI Adapter.