Extension Cords; Loading Tool - Craftsman C583-930360 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Extension Cords

Use only three-prong, grounded extension cords marked for outdoor use.
Be sure to use the right size extension cord. If cord size is wrong, tool may
be damaged. Tool performance may also be affected. Use only a three-
prong, grounded extension cord.
Extension Cord Size Requirement
1 to 12 feet, use 16 AWG rated cord
12 to 50 feet, use 14 AWG rated cord
Inspect extension cord often. Replace cord if worn or damaged.

Loading Tool

Never load tool while it is plugged in. Accidental discharge may
occur. Before loading, move trigger lock to the OFF position and
unplug tool.
1. Move trigger lock to the OFF position. See PRODUCT IDENTIFICA-
TION on page 4 to locate trigger lock.
2. Unplug tool.
3. Remove nail pusher from nail chamber. Access nail pusher at rear of
nail chamber. Push end of nail pusher in and down to release it (see
Figure 2). Pull nail pusher from nail chamber (See Figure 3).
Figure 2
!
CAUTION
WARNING ICON
G 001
!
WARNING
WARNING ICON
G 001
1
2
Nail Pusher
Figure 3
5
Nail Pusher

Publicité

Table des Matières
loading

Table des Matières