Craftsman C583-930360 Mode D'emploi page 3

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9. Keep work area well lit.
10. Move trigger lock to the OFF position and unplug tool
• when loading tool
• when not in use
• when moving from one place to another
• before maintenance
• when changing accessories
11. Do not alter this tool in any way.
During Operation of Tool
1. Keep all parts of body away from nail opening on tool.
2. Never point tool at anyone.
3. Keep children, animals, and bystanders away from tool and extension cord at all
times. Only tool user should be in work area.
4. Stay alert. Use common sense while operating tool.
5. Keep trigger lock in the OFF position and finger off trigger until ready to drive nail.
6. Keep work area clean. Cluttered work areas invite injuries.
7. Secure work before using tool. Use both hands to operate tool.
8. Do not touch any metal part of tool when nailing into areas where electrical wiring
may be present. These areas include walls, floors, and ceilings. If nail contacts
electrical wire, electric shock may occur.
9. Avoid body contact with grounded objects such as pipes, fences, and metal posts.
10. Do not force tool. Use tool at rate for which it was designed.
11. Do not overreach. Keep proper footing and balance at all times.
12. Carry tool from one place to another
• with tool unplugged
• with trigger lock in the OFF position
• with finger off the trigger
General
1. Inspect tool before and after each use. Check tool closely if it has been damaged.
Check for any damage that may affect operation of tool. Check for alignment or
binding of moving parts. Check for broken or damaged parts. Do not use tool if
damage affects operation. Have damage repaired by factory service center.
2. When servicing, use only identical replacement parts.
3. Maintain tool with care.
• Never fire tool when empty of nails. This may damage tool.
• Keep tool clean.
• Keep handles dry, clean, and free of oil and grease.
• Inspect power cord often. If damaged, have repaired by factory service center.
• Never carry tool by power cord.
• Never yank power cord to unplug it.
• Keep power cord away from heat, oil, and sharp edges.
• Inspect extension cords often and replace if damaged.
• Never oil or grease any part of tool.
4. Always store tool
• with nails removed from chamber
• out of children's reach
• in a high or locked place that is dry
Keep these operating instructions for reference. It is your guide to safe and proper
operation of this tool.
3

Publicité

Table des Matières
loading

Table des Matières