Daily Maintenance; Maintenance; Usb Connection; Troubleshooting - Husqvarna PP 70 Manuel D'utilisation

Masquer les pouces Voir aussi pour PP 70:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.

Daily maintenance

WARNING: Disconnect the product from the
power supply and wait minimum 5 minutes
before you start the maintenance.
CAUTION: Do not use a high pressure
washer to clean the product. The high
pressure can cause damage to the seals
and cause water and dirt to come into the
product.
Do a check of the safety equipment. Make sure that
it is not damaged. Refer to
product on page 6 .
Make sure that the power cord and the extension
cable are in good condition and not damaged.
Make sure that the water hose and water couplings
are in good condition and not damaged.
Always clean the product at the end of the work day.
Use a heavy duty handheld brush or a large paint
brush.
Explanation of the status indication
lamps
10

Maintenance

Safety devices on the

Troubleshooting

Keep the connectors and pins clean. Clean with a
cloth or brush.
Make sure that the water system is not damaged.

USB connection

The product has an USB connection.
CAUTION: Only approved brand service
person must use the USB connection.
The status indication lamps help you to do
troubleshooting.
The light is on.
The light is off.
The light is constant.
The light flashes quickly.
1244 - 002 -

Publicité

Table des Matières
loading

Table des Matières