CABASSE ABYSS Notice Utilisateur page 36

USE / SYNCHRONIZE WITH A TV SET
MODE TV
1. Please connect the primary speaker to the TV with the TV cable, please connect the primary
speaker to the secondary speaker with the optical cable.
2. If you find latency between the picture and sound of your speakers, please try the time delay
or audio synchronization feature of your TV set if available.
3. If the TV icon does not appear on the primary speaker display, the TV connection is not
found. Check your connections or replace the TV cable.
4. With this connection, you can control the volume of your system via your TV remote control.
ADJUSTING THE LATENCY OF YOUR SPEAKERS
Choose the coaxial SPDIF solution.
There are 3 modes that will allow you to adapt the latency of your audio system to your needs:
- TV/DIRECT: This mode does not use the network. The sound is broadcast directly from the
audio input to the device. Therefore, the sound must be distributed to each device in the zone
and all must have the same configuration.
- Low latency: This mode allows the streaming of one device to the others. The latency is less
than 1 second, the stability of this setting will depend on the quality of the network and the
bandwidth. If one of your devices cuts out, it is generally due to a lack of buffering data, a wired
Ethernet connection is preferable to a wireless connection.
If this setting remains unstable, we advise you to configure the direct TV mode so as not to
depend on your network.
DEACTIVATION OF THE SPEAKERS OF THE TELEVISION
Turn on the TV, open the TV menu, and look for a tab such as Audio, Sound or Speakers. Use
the menu function to switch off the TV speakers. This menu item may for example be labeled
«Speaker On / Off» for speakers on / off. If this function does not exist, bring the TV sound
volume with the TV remote control to the minimum level.
ACTIVATION OF THE OPTICAL OUTPUT OF THE TELEVISION
If there is no sound with an optical connection, set the chosen optical output in the TV menu if
necessary.
36