Automatic Shut Off - KING MaxiSteam P 733 Mode D'emploi

vaporization, so that you can iron the most delicate fabrics without risk of spoiling or
staining them.

AUTOMATIC SHUT OFF

The automatic shut off device trips after the iron has been left for approx. eight minutes
in the upright position or unused for approx. Thirty seconds in the horizontal position.
The light comes on to indicate that shut off has tripped. As soon as you move the iron,
the device turns off and the iron starts working again.
Cleaning
1.Disconnect the appliance from the mains , before cleaning.
2.Do not use solvents or abrasive products to clean the iron , clean with a damp cloth.
Defects and repairs
Do not attempt to replace a defective mains lead .The appliance has to be returned to
an authorized service centre for repair.
Faults-reasons and solutions
Iron emits an odor or smoke
Iron gives off an odor when turned on for the first time. Oils used during manufacture
need to be burnt off allow ten minutes for odor to disappear.
Iron does not heat
The iron should be plugged into a 230 Volt , AC electrical outlet only. The temperature
dial must be set at the desired temperature.
Iron does not steam
The water tank many be empty. Turn the steam valve to "0" and add water .Allow the iron
to heat, and then set the steam dial to the steam setting.
Burst of steam feature does not work
The water tank must be at least 1/4 full .Temperature must be set to steam position. Iron
should be in the horizontal position. Prime pump briefly. Allow a short pause between
shots. Be sure to fully depress the burst of steam button.
Spry mist feature does not work
The water tank must be at least 1/4 full. Fill the iron as described in the section "how to
fill the water tank".
Iron is leaking
The variable steam dial must be set on" ",until the iron is hot . The temperature setting is
too low to produce steam. Shot of steam used too much, allow iron to re-heat.