Anti-Calc System; Anti-Drip System - KING MaxiSteam P 733 Mode D'emploi

ture control are selected. Otherwise ,water may escape through the soleplate.
4.Wait until the pilot light goes out , which indicates that the selected temperature has
been reached.
5.Turn the steam button to the required position.
6.When the ironing is finished and during breaks in ironing , place the iron in its upright
position.
7.Disconnect the iron from the mains supply . Pour of any remaining water and leave the
iron to cool off.
Spray
1.The spray can be used in any position, either in dry or steam ironing, as long as the
water tank is filled with water.
2.Press the spray button for this function
NOTE:
This button has to be pressed repetitively to start this function for the first time.
Shot of steam
Shot of steam give extra steam for removing persistent wrinkles.
1.Place the temperature selector at the "max"position and wait until the pilot light goes
out
2.Wait for a few seconds for the steam to penetrate the fibre before pressing again.
NOTE:
For the best steam quality, do not use more than three successive bursts each
time. Several pumping actions are needed to start this function.
Excessive use of this feature will cause the iron to cool , ensure that the pilot light is out,
before operating the shot of steam control

ANTI-CALC SYSTEM

A special resin filter inside the water reservoir softens the water and prevents scale
build-up in the plate. The resin filter is permanent and does not need replacing.
Please note:
Use tap water only. Distilled and/demineralised water makes the "Zero-Calc" anti-calc
system ineffective by altering its physicochemical characteristics.
Do not use chemical additives, scented substances or decalcifiers. Failure to comply
with the above-mentioned regulations leads to the loss of guarantee.

ANTI-DRIP SYSTEM

With the anti-drip system, you can perfectly iron even the most delicate fabrics.
Always iron these fabrics at low temperatures. The plate may cool down to the point
where no more steam comes out, but rather drops of boiling water that can leave marks
or stains. In these cases, the Anti-drip system automatically activates to prevent