Applications - PrimeCables CAB-CAP110 Mode D'emploi

!
The inflator is not designed for continuous use. For every five minutes of inflator use, five
NOTICE:
minutes of cool down time are required.
Since the pressure gauge is not calibrated, and is therefore not binding for exact values,
WARNING:
!
tire pressure must be checked using a reliable measuring device be- fore driving a vehicle
with vehicle tires inflated with the inflator. Driving a vehicle with improperly inflated tires
could result in serious injury.
The inflator is capable of inflating to 6.8 Bar. To avoid over inflation, carefully follow
NOTICE:
!
instructions on items to be inflated. To avoid product damage, never exceed recommended
pressures.

APPLICATIONS

!
You may use this inflator for the purpose listed below: Inflating items such as motorcycle, car, and
bicycle tires.
NOTE: The inflator is not designed for commercial applica- tions.
Battery tools are always in operating condition. Always remove battery pack from your tool
WARNING:
!
when you are as- sembling parts, making adjustments, cleaning, or when not in use.
Removing battery pack will prevent accidental starting that could cause serious personal
injury.
TO INSTALL/REMOVE BATTERY PACK
To install:
1. Place the battery pack in the tool. Align the rib on the battery pack with groove in the battery port.
2. Make sure the latches on the battery pack snap in place and that the battery pack is secured in the
tool before beginning operation.
To remove:
Depress the latches in the front of the battery pack to release the battery pack and remove it from the
tool.
AIR HOSE AND ACCESSORY STORAGE
When the inflator is not in use, press the hose into the storage area on top of the tool.
When not in use, adaptors and needles provided with the inflator can be placed in the storage area of
the tool.
LED WORKING LIGHT
When working, the LED light on the base of the tool is on, which is good for nightwork.
START SWTICH AND SELF-LOCKING SWTICH
1. When press start switch, push self-locking switch up, which will make the switch in LOCK-ON.This
guarantees the safety for the user and of the tool.
2. After the pressure enough, pressing the start switch, then the self-locking switch will sprang back down.
USING THE INFLATOR
See Figure 1
1. Install the battery pack.
2. Position air chuck clamp in the unlock position perpen- dicular to the air hose.
3. Place the air chuck on the valve stem.
4. Push the air chuck down so that the threaded section of the valve stem is inside the air chuck.
Clamp the end of the air chuck down onto the valve stem by pressing air chuck clamp down until it stops
or is parallel with the air hose.
OPERATION
7