Inglesina Caboto 1.2.3 iFix Manuel D'instructions page 17

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
place. The display window (18) will turn from red to green. Push the
child car seat as back as possible. Make sure that both Isofix (5) are
in the same position once you have pushed the child car seat back.
4.
Connect the Top Tether to the intended
anchor point in the vehicle marked with the
symbol.
Lastly, tighten the strap of the Top Tether system until the green
signal is displayed on the indicator. The strap should go over the
backrest of the vehicle seat. If necessary lift the headrest or remove
it.
Caution! Make sure that the connectors are correctly fastened into
the anchor points of the vehicle by pulling the child car seat once
it has been installed.
To detach the child car seat follow the same steps in reverse: move
the lever (15) to open the connectors and release the anchors.
FROM 15 KG TO 36 KG
To install the child car seat, follow the steps explained above
without connecting the Top Tether (4).
There is also the possibility of installing the child car seat only with
the vehicle seat belt.
POSITIONING THE CHILD INTO THE CHILD CAR SEAT
5.
The child car seat may be used for the following weight ranges:
- 9-18 KG The child must be always secured using the child
car seat safety harness.
- 15-36 KG The child car seat safety harness must be stored
away and the child must be secured with the vehicle seat
belt.
USING THE CHILD CAR SEAT'S SAFETY HARNESS
(ONLY IN CONFIGURATION 9-18 KG)
6.
Loose the harness by pressing the button (10) then unfasten
the buckle (9) by pressing the red button.
Position the child in the child car seat and fasten the buckle.
7.
Tight the harness by pulling the lower strap (11).
To get the child out of the child car seat follow the same process in
reverse (fig. 2A).
HOW TO REMOVE THE SAFETY HARNESS
Once the child reaches a weight of 18 kg the child car seat's safety
harness should be stored away and the child should be secured
with the vehicle safety belt.
8.
Follow the instruction on the shoulder label to detach and
store the harness straps. Lift the seat fabric cover and store the
crotch buckle in the compartment. Then put the fabric cover back
over the seat.
17

Publicité

Table des Matières
loading

Table des Matières